CONTROLS/INSTRUMENTS
2 - 14
2. Backrest
Lift lever to select proper adjustment angle of
backrest.
3*. Fore-and-Aft
Pull handle up and slide seat forwards or
backwards to adjust distance between seat
and dashboard.
4*. Incline
Pull handle up, and adjust seat inclination.
Warning:
Before proceeding with seat cushion
adjustments, lower seat belt retractor to avoid
pinching fingers between retractor and control
knobs.
(*) If your vehicle has electric
ISRI
seats,
controls 3 & 4 change. For description of
electric controls, see
Electric
ISRI
Seats
on
this page.
5. Suspension
For maximum suspension performance, push
or pull knob until desired damping is reached.
6. Raise/Lower
Press on
+
or
-
to respectively raise or lower
driver's seat.
7. Lumbar Support
Push on upper section of rocker switches to
inflate lumbar support bellows inside the seat
backrest, and push on lower section of rocker
switches to deflate bellows.
Note:
Rear and front rocker switches are re-
spectively for upper and lower lumbar support
bellows.
Heated Cushions
The
ISRI
seat may also be equipped with back
and seat heated cushions, operated by a switch
mounted on R.H. lower switch panel (See items
#5 and #7 on page 2-3).
Electric
ISRI
Seats
Adjust electric seats as follows:
18040
1. Tilt (rear)
Pull switch up to raise rear section of seat.
Push switch down to lower rear section of
seat.
2. Fore-and-Aft/Up-Down
Push switch towards dashboard to move seat
forwards or back to move seat backwards.
Pull switch up to raise seat & push switch
down to lower seat.
3. Tilt (front)
Pull switch up to raise front section of seat.
Push switch down to lower front section of
seat.
4. Memory
• Use switches (items 1,2 & 3) to adjust the
seat to the position desired by driver
1
.
• Press the
SET
button and then the number
1
button. Memory position
1
is now set.
• To set the seat position for driver
2
, repeat
steps 1 and 2 except press the number
2
button in step 2. Memory position
2
is now
set.
• To move the seat to either memory position,
press and hold the desired button (
1
or
2
) for
at least 2 seconds. If the seat does not move,
the button was not held long enough or the
seat is already in the desired position.
• To use the easy entry/exit feature, press and
hold the number
1
and the number
2
buttons
at the same time for at least 2 seconds. The
seat will move to the full rear and full down
position.
