CONTROLS/INSTRUMENTS
2 - 5
4. Blank for Additional Switch
5. Exterior Mirror Heating Switch
Push down rocker switch to heat both outside
mirrors. Integral Thermostats are installed in
both mirrors to avoid continual heating.
6. Blank for Additional Switch
7. Fog Light Switch
Push down rocker switch to activate fog lights as
well as clearance, tail and marker lights. Before
using fog lights, remove protective covers by
pulling on their edges.
Warning:
Before removing protective covers,
stop engine and apply parking brake.
8. Headlight Switch
Push down rocker switch to the first position to
activate clearance, tail and marker lights and to
the second position for headlights.
Note:
Daytime running lights will be automati-
cally canceled when this switch is pushed to the
second position. For system information, refer to
section
Safety
under heading
Daytime Running
Lights
.
9. Hazard Flasher Switch
Push down rocker switch and all turn signals will
flash simultaneously, as well as their dashboard
indicator lights.
10. Baggage Compartment Door
Indicator Light
Illuminates when one or several baggage com-
partment door(s) is (are) unlocked.
11. Batteries With a High or Low Voltage
Illuminates when battery voltage exceeds 30
volts or drops below 24 volts.
Note:
According to the battery charge, this indi-
cator light will normally turn on upon engine
starting and remain on during a few seconds.
This is caused by a normal voltage drop during
starting.
12. Battery Balance
Illuminates when batteries are not balanced.
Note:
Before requesting any breakdown serv-
ice, check that battery equalizer circuit breakers
are reset. For their location, refer to heading
Main Breakers
(see page 4-11). Allow at least
15 minutes to balance batteries after corrective
measures have been taken.
13. Electrical System Indicator
Illuminates when the ignition switch is
OFF
and
the 12-volt and 24-volt electrical systems are ac-
tivated by depressing the battery master switch
located on the L.H. lower control panel.
14. Blank for Additional Indicator Light
15. Turbo Boost Pressure Gauge
(optional)
Indicates turbo boost pressure in psi. Reading
depends on engine rpm and load conditions.
16. Oil Pressure Gauge
Indicates engine oil pressure. Normal reading
should range between 50 and 70 psi (345 -
485 kPa) at cruising speed.
17. 24 Volt Voltmeter
Indicates electrical system voltage. Normal reading
should be 27.5 volts with engine operating.
18. Adjustable Ventilation Louver
The louver is manually adjustable, so the heated
or cooled air flow can be directed as desired.
19. Pyrometer Gauge
(optional)
Prior V.I.N. 2P9V33499S1001152 only
Indicates exhaust manifold temperature in hun-
dreds of °F. Normal reading should vary between
500 °F (260 °C) and 1100 °F (600 °C) according
to operating conditions. Temperature should not
exceed 1100 °F (600 °C).
20. 12 Volts Voltmeter
Indicates electrical system voltage. Normal
reading should range between 12 and 13.75
volts with engine operating.
