RBK 815 Recumbent Cycle
Page 24
6.
If the measurement in step 3 is significantly low or high, disconnect the
interconnect cable from the J2 connector and repeat the measurement in step 4.
7.
If the measurement in step 6 is still significantly low or high, replace the lower
PCA. If replacing the lower PCA does correct the problem, skip to step 9.
8.
Remove the upper display panel and disconnect the interconnect cable from the
upper PCA. With the unit powered up, check the voltage between the outer two
pins of the interconnect cable for DC volts. It should read approximately 8.5 Vdc.
If the voltage is absent or significantly low, troubleshoot the interconnect cable.
9.
If the voltage measurement in step 4 is correct, replace the upper PCA.
10. If you have performed all of the previous tests and have not been able to locate
the trouble, call Precor customer support.
Содержание RBK 815
Страница 23: ...RBK 815 Recumbent Cycle Page 23 Diagram 6 1 Lower PCA RBK 815 TP19 TP20 J2 M6 M7 J4 M1 M2 M3 M4 M5 ...
Страница 31: ...RBK 815 Recumbent Cycle Page 31 replace the heart rate PCA to handlebar wire harness ...
Страница 40: ...RBK 815 Recumbent Cycle Page 40 14 Replace the covers per Procedure 7 1 ...
Страница 59: ...RBK 815 Recumbent Cycle Page 59 Block Diagram 8 2 RBK 815 ...
