RBK 815 Recumbent Cycle
Page 50
Procedure 7.13 - Replacing the Lower PCA
1.
Remove the top, rear, left and right covers per procedure 7.1.
2.
Disconnect all of the wires from the lower PCA.
3.
Remove the four screws that fasten the lower PCA. Remove and discard the
lower PCA.
4.
Set the replacement lower PCA in its mounting position and fasten it with the four
screws removed in step 3.
5.
Reconnect the wiring to the lower PCA as follows: two red generator magnet
wires to M1, M2; red generator wire to M3, white generator wire to M4, black
generator wire to M5; red battery wire to M6, Black battery wire to M7; the data
cable to connector J2. See Diagram 7.14.
Diagram 7.14 - Lower PCA
6.
Replace the covers per Procedure 7.1.
Black Battery Wire
Red Battery Wire
Data Cable
Red, White Black
Generator Wires
Generator
Magnet Wires
Содержание RBK 815
Страница 23: ...RBK 815 Recumbent Cycle Page 23 Diagram 6 1 Lower PCA RBK 815 TP19 TP20 J2 M6 M7 J4 M1 M2 M3 M4 M5 ...
Страница 31: ...RBK 815 Recumbent Cycle Page 31 replace the heart rate PCA to handlebar wire harness ...
Страница 40: ...RBK 815 Recumbent Cycle Page 40 14 Replace the covers per Procedure 7 1 ...
Страница 59: ...RBK 815 Recumbent Cycle Page 59 Block Diagram 8 2 RBK 815 ...
