page 11
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
You do not need any special knowledge or experience to set up the treadmill.
However, because of the size and weight of the treadmill, you will need to obtain
assistance.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the treadmill.
If you do not
install the treadmill according to the following guidelines, you could void the Precor
Limited Warranty.
•
Set up the treadmill on a solid, flat surface
. Unpack and assemble the
treadmill close to where you plan to use it. Make sure that the flat surface
under the unit is smooth and level. A level unit is required for the user’s safety
and proper operation.
•
Provide ample space around the unit
. Open space around the unit makes
for a safer mount and dismount.
•
Fill out and mail the warranty registration card
. Be sure that the treadmill
is turned OFF. The serial number can be found on the shipping container or on
the label near the power receptacle. Write the serial number onto the Precor
Limited Warranty registration card found on the back cover of this manual.
Refer to
Obtaining Service on page 7 and write the number(s) there as well.
•
Use the appropriate voltage, dedicated circuit, and grounding as speci-
fied on the treadmill.
The treadmill is available in both 120-volt and 240-volt
models. Refer to the treadmill’s identification label to determine the voltage
that your treadmill requires. Both the 120-volt and 240-volt models require a
dedicated
circuit. A 20 amp circuit is recommended.
CAUTION: Do not use a non-grounded outlet or transformer. Do not
remove or otherwise bypass the plug with an adapter. Electrical
damage can occur and void the Precor Limited Warranty if the treadmill
is connected to an improper power source.
ASSEMBLY INSTRUCTIONS
Take the following steps to assemble the treadmill.
1.
Obtain adult assistance
. Have your assistants help place the shipping carton
close to the location where you plan to use the treadmill. Break down the side
walls of the shipping carton so that they lie flat. Remove the loose contents.
CAUTION: To avoid injury and ensure your safety, get assistance
before lifting the treadmill off the pallet and rolling it onto the floor. Do
not drop the unit.
2.
Make sure that the power switch is OFF
. Check the ON/OFF power switch
on the front of the treadmill. Place the switch in the O (OFF) position. Make
sure that the treadmill is
not
plugged into a power source.
Setting Up the Treadmill
