Large Display Temperature Meters
Instruction Manual
31
General Programming Description
When power is applied to the meter, the display flashes
188888
, then it displays
the temperature from the sensor.
To program the meter lockout jumper JP2 must be removed.
After pressing the
ENTER
button, the display will scroll through the following
functions in the order shown:
Display
Type of Function
HI t
Displays maximum temperature
LO t
Displays minimum temperature
CALIb
Calibrates meter for selected input type.
OFFSEt
Sets offset value to the input, negative or positive
type
Sets the type of T/C or RTD to be used
F or C
Sets temperature scale, Fahrenheit or Celsius
SetuP
Sets alarm set points for latching or non-latching operation
SetPtS
Sets alarm set and reset points.
output
Sets 4 and 20 mA output points, if this option is installed.
dIA9
Displays parameter settings one at a time for diagnostic
purposes.
Five Basic Digit/Display-Setting Instructions
1. If flashing display is OK, press
ENTER
to accept it, before display stops
flashing.
2. If flashing display is not OK, (or if
ENTER
was not pressed in time to accept
it), wait for the first digit to flash.
3. If a flashing digit is OK, press
ENTER
to accept it, before it starts to scroll.
4. If a flashing digit is not OK, (or if
ENTER
was not pressed in time to accept
it) wait for digit to scroll, and press
ENTER
when OK.
5. Digits will scroll until
ENTER
is pressed. When a digit is accepted by
pressing
ENTER
, next digit flashes.
