Precisa 360 ES Series, Руководство по эксплуатации

Страница: 22 / 77

■ 10 Operation
20
„AUTO-STANDBY“
The Auto-Standby mode turns off the balance automatically, if:
• the balance is tared and has shown “Zero” for at least 5 minutes
• the balance has received no remote control command via the interface for at least 5 minutes,
• the automatic zero correction „AUTO-ZERO” is activated.
It is possible to re-start the balance after it has been switched off by an automatic Auto-Standby:
• Briefly press any key
• Put a weight on the balance
• Make a remote control command via the interface
„AUTO-ZERO“
If the automatic zero correction „AUTO-ZERO” is activated, the balance always gives a stable zero (e.g. even
with fluctuations in room temperature).
„ZERO-RANGE“
Defines the maximim weigth to performe a zero function instead of a normal tare when pressing « T » or sen-
ding the remote command to tare. This value can be adjusted to make sure a small load is saved as tare and
printout e.g. on a report as tare value.
10.3.6 Interface functions
The RS232/V24 interface on the device is matched to the interface of a peripheral device with the aid of the
interface functions (see chapter 21 "Data transfer").
„PC DIRECT MODE“
Enables/disables the PC direct mode (see chapter 21 "Data transfer").
10.3.7 Date and time.
• SET INTERFACE
BAUDRATE 300
600
1200
2400
4800
9600
19200
38400
57600
Select baud rate
PARITY 7-EVEN-1STOP
7-ODD-1STOP
7-NO-2STOP
8-NO-1STOP
8-EVEN-1STOP
8-ODD-1STOP
Select parity
HANDSHAKE NO
XON-XOFF
HARDWARE
Select handshake function
PC DIRECT MODE ON/ OFF Select PC direct mode
• SET
DATE AND TIME
DATE [DD.MM.YY]
TIME [HH.MM.SS]
FORMAT STANDARD /US
Set date and time
NOTE
If a power failure occurs, the timer continues running. If this does not happen, this indicates that the
instrument's backup battery has expired and has to be replaced by the Customer Service.