13
6
Shortcut Operations
SqUElch lEVEl SETUp
This function is used to setup the level of receiving signals. When the
signal strength reaches a certain level, it will unmute the transceiver.
In standby, press and hold
key; meanwhile turn the selector knob
to adjust the squelch level of Main band.
1-20:
20 squelch levels are available.
OFF:
turn off squelch. The background noise will remain on.
The squelch level setup is for right band and left band separately.
TRAnSMiT DTMF/2 TonE/5 TonE SiGnAlinG
If the current channel is programmed with DTMF / 2-Tone / 5-Tone
signaling, hold PTT and
[ UP ]
key will transmit selected preprogrammed
signaling.
hiGh/MiD/low TRAnSMiT powER SwiTch
In standby, repeatedly press key to choose power levels as follows:
When LCD displays HIGH, the power for current channel is high.
When LCD displays MID1, the power for current channel is middle 1
When LCD displays MID2, the power for current channel is middle 2.
When LCD displays LOW, the power for current channel is low.
Output power for each level:
HIGH
MId1
MId2
LOW
VHF (50 W)
VHF (20 W)
VHF (10 W)
VHF (5 W)
UHF (40 W)
UHF (25 W)
UHF (10 W)
UHF (5 W)
In channel mode, this operation is for temporary use only
This function is valid only when current channel is programmed with
repeater offset frequency and offset direction
In standby, press
key to switch to HOME
channel, and communicate on HOME channel.
Repeatedly press it to return to last channel.
In standby, hold key for one second to turn On/Off frequency
reverse function. When reverse function is on, the TX frequency will
change to RX frequency and RX frequency will change to TX frequency.
The signaling will also be reversed for CTCSS/DCS signaling set in this
channel.
hoME chAnnEl
FREqUEncY REVERSE
This transceiver has three bandwidths. Select suitable bandwidth in
accordance with different local conditions.
In standby, hold key for one second to choose the three bandwidths.
When LCD displays
WIdE
, current channel is working on wide band
25 kHz. When LCD displays
MIddLE
, current channel is working on middle
band 20 kHz. When LCD displays
NARROW
, current channel is working
on narrow band 12.5 kHz. Per FCC Rules, in North America wide band
and narrow band is used. See top of page 36 for band plan.
BAnDwiDTh SElEcTion
NOTE
NOTE
NOTE
hYpER MEMoRY chAnnEl
In standby, press the left or right volume knob to switch the radio to work
on hyper channel 1 or hyper channel 2.
