31
8
Microphone Operation
SEnD DTMF SiGnAlinG
MAin/SUB BAnD SwiTchinG
FUncTion opERATion ThRoUGh pA-pD kEYS
You can operate the transceiver by keypad or input desired frequency
and channel through the microphone.
Hold the PTT key; input the desired DTMF signaling by the numeric keys.
This transceiver is defaulted on dual receive, in this status, a MAIN icon
will display in the top right corner of the main band frequency; transmitting
is only available on the main band. In standby, you can switch main band
and sub band by the A/B key.
This function is valid only when current channel is set with offset frequency.
PRI:
Add or delete priority channel. In
channel mode, press the key programmed
as
PRI
function to set priority channel. When the LCD displays the
current channel is set as priority channel. Repeat above operation; the
disappears, and the curent channel is not set as priority channel.
LOW
: Output power setup. In standby,
press the key programmed as
LOW
function
to change the power level. When LCD displays HIGH, the transmitting
power on current channel is high. When LCD displays MID1, the
transmitting power on current channel is middle 1, When LCD displays
MID2, the transmitting power on current channel is middle 2. When LCD
displays LOW, the transmitting power on current channel is low.
TONE
: CTCSS/DCS code setup. In standby,
press the key programmed as TONE function
to setup CTCSS/DCS code. When the LCD
displays "
ENC
" and CTCSS frequency, press the [
UP/dOWN
] key
to choose CTCSS encode. When the LCD displays "
ENC
","
dEC
" and
CTCSS frequency, press the microphone
[
UP/dOWN
] key to choose
CTCSS decode. When the LCD displays "
dCS
" and DCS code, press the
microphone
[
UP/dOWN
] key to choose DCS code.
M H Z
: In VFO mode, press the key
p r o g r a m m e d a s M H z f u n c t i o n ; t h e
m e g a b i t d i g i t a l i n t h e L C D f l a s h e s .
Now turn the channel knob or microphone
[
UP/dOWN
] key to
adjust frequency by 1 MHz step. In channel mode, press this key;
the channel number flashes. Adjust selector knob or microphone
The PA,PB,PC,PD, keys are programmable with the following functions.
See page 25 for microphone programming.
RPTR:
OFFSET direction setup. In standby,
press the key programmed as RPTR function to change the offset
direction. When LCD displays"
+
", means TX offset id plus; when the LCD
displays"
-
", means TX offset is minus.
NOTE
1
4
7
8
9
0
#
5
6
2
3
PA
MIC
PB
A
B
A
A/B
B
PC
PD
MAIN
PTT
Main/Sub band switch
UP
DOW
N
MIC
Numeric Keys
Microphone speaker
