Powermatic PJ-882, Инструкция по эксплуатации и каталог запасных частей

Страница: 24 / 48

24
Eliminating “Play” in Tables
There are four set screws at the front of the
jointer – two on the outfeed table and two on the
infeed table – that will allow you to prevent
“play” in the tables. (Figure 38 shows a set
screw for the outfeed table.)
After a period of use, the copper tip (see item
#27, page 37) which is attached to the end of
the set screw (A, Figure 38) may become loose.
Resolve this as follows.
1. Loosen the hex nut (B, Figure 38) with a
14mm wrench.
2. Tighten the set screw (A, Figure 38) with a
5mm hex wrench. Do not overtighten the set
screw, as it may prevent the table from
being raised and lowered easily.
3. Tighten hex nut (B, Figure 38).
4. Repeat for the other set screws as needed.
NOTE: The outfeed table is pre-set at the
factory tighter than the infeed table. If you find
the outfeed table difficult to move with the lifting
handle, loosen the two set screws on the
outfeed table, as just described.
Operating Controls
Press the start switch, shown in Figure 39, to
begin rotation of the cutterhead. The stop button
is a mushroom style button which is convenient
for "emergency" shut-downs.
After being pushed, the stop button remains
engaged. To re-start the Jointer, twist the stop
button clockwise until it pops back out.
Operation
NOTE: If you are inexperienced at jointing, use
scrap pieces of lumber to check settings and get
the feel of operations before attempting regular
work.
Stabilize long workpieces by using an assistant,
or roller stands set level with the outfeed or
infeed table surface.
The fence should be adjusted to create
minimum exposure to the cutterhead during the
jointing operation.
Check the following before operating the jointer:
1. Outfeed table must be set level with the high
point of the knives.
2. Fence adjusted for minimum exposure of
cutterhead, and locked at desired angle.
Figure 38
Figure 39