Powermatic PJ-882, Инструкция по эксплуатации и каталог запасных частей

Страница: 18 / 48

18
9. Each table has four cam adjustment
devices; two in front and two in back.
NOTE: On the front of the Jointer, the two
outside cams are concealed by the hubs.
You must remove the hub to expose the
cam adjustment device. Remove the socket
head cap screw and flat washer at the
center with a 6mm hex wrench, and loosen
the two setscrews in the hub (Figure 21
shows one of the two set screw holes). Pull
the hub straight out to expose the cam
adjustment device.
10. At the area of the table where the
adjustment must be made, pry out the cap
(A, Figure 22) from the hole.
11. There are two set screws in the hole. Insert
a 4mm hex wrench (B, Figure 22) into the
hole and loosen the upper set screw by
turning the hex wrench counterclockwise.
Remove the upper set screw from the hole.
12. Loosen the lower set screw (do not remove
it) by turning counterclockwise with the hex
wrench.
13. Turn the hex nut (C, Figure 22) with a 1-1/4"
wrench. This adjustment is sensitive and
should be made in small increments.
NOTE: The rotation is different for left and
right hex nuts; the right hex nut being turned
in Figure 22 will be turned clockwise to raise
that area of the table, or counterclockwise to
lower that area of the table. The left hex nut
shown in Figure 22 would be rotated in the
opposite manner.
14. Use the straight edge upon the table and
across the cutterhead to check the
adjustment until the table is parallel with the
cutterhead.
15. When the adjustment is satisfactory, with
the tables now parallel to the cutterhead,
tighten the lower set screw with the hex
wrench (B, Figure 22).
16. Insert and tighten the upper set screw.
17. Re-insert the cap (A, Figure 22) to keep
dust and debris out of the hole.
Setting Knives at Correct Height and
Parallel To Outfeed Table
For accurate jointing, the outfeed table surface
must be level with the knives at the high point of
their arc. Also, the knives must be parallel with
the outfeed table along the entire length of the
knives.
Figure 21
Figure 22
(back of outfeed table shown)