PowerBoss 82 Europe, Руководство пользователя

Страница: 70 / 88

PowerBoss, Inc. Copyright 2011
Monitor Series PB# 4100031 Rev.B 09/11
Page 70
MAIN SQUEEGEE COMPONENTS
Checking and Adjusting the Rear Main Squeegee
Flare
NOTE: Perform step # 16 before proceeding to
make adjustments
1. Park the machine on a flat surface. Lower the
squeegee.
2. Turn the machine off and engage the parking
brake.
3. Open the access doors to the disc scrub
brushes.
4. Locate & remove the pull pins for the side
squeegees, remove the side squeegees.
5. Lower the squeegee assembly
6. Release the quick-disconnect at the back of the
rear squeegee.
7. Loosen the locking nut on the squeegee caster
and screw the caster up until it clears the floor.
With the squeegee straight up on the floor (no
flare), adjust the caster until it clears the floor
by ½” (12.7 mm). Use a ½” (12.7 mm) shim
spacer of metal or wood as a feeler gauge for
this procedure. This is a starting reference.
8. Locate the squeegee lift arms on each side of
the machine.
9. Loosen the bolt which attaches the upper
squeegee lift arm to the squeegee mounting
plate on each side.
10. Locate and loosen both jam nuts on each
squeegee tilt adjustment link and back them
away from the gussets. The rear squeegee is
now free to be aligned with the floor. Lift the
squeegee tool by hand and allow it to rest back
on the floor, this will seat the tool to the floor.
Again it should stand straight on the floor with
no flare.
11. Check the squeegee rubber to make sure the
squeegee makes contact with the floor all the
way around.
12. At each squeegee arm mount, turn the two
jam nuts on the tilt adjusting link until they both
make contact with the mounting plate on each
side.
PREVENTATIVE MAINTENANCE