Power i-Cruise Dial, Инструкция по эксплуатации, Страница: 7 / 36

Installation notes
The wiring method, and installation
Please do not install to any vehicles other than a conformity vehicle
type. Fault which trouble produces to a run arises, or vehicles may be
damaged and it is dangerous.
Please stop attaching a main part unit and an operation unit to a handle, a shift
lever, a pedal, and the other places that become the hindrance of operation, or
managing wiring. It becomes a cause of an accident and is very
dangerous.
Please install neither a main part unit nor an operation unit a place
humidity and dusty, the place where direct rays hit, the place where it
is filled with heat, near the jet of a heater, etc. It becomes a cause of
discoloration of a main part, modification, malfunction of a product,
failure, or breakage.
Please be sure to extract a key from a key cylinder and to remove the
minus terminal of a battery, when doing wiring work. There are the
breakage of this product, the breakage of vehicles, and fear of a fire by
short‑circuit of wiring, and it is very dangerous.
When the valve of a pure brake lamp is an electric bulb type, please do
not change into an LED type.
Although a brake is stepped on, there is a possibility that the danger
of being unable to cancel auto‑cruise may arise.
Please be sure to use the harness according to vehicle type for
exclusive use for attachment of this product.
The attachment should go in a specialty store. If mistaken wiring is
performed, it will become a cause of serious troubles, such as a
vehicle fire.
When you perform wiring at the place which is easy to be subject to
influences of water, such as an engine room, please be sure to perform
insulated processing and waterproofing processing to a connection
section.
When you take out and insert a connector, please work holding a
connector main part. There is a possibility of disconnecting if harness
is pulled and impossible power is applied.
‑6‑
Warning
Caution