Power i-Cruise Dial, Инструкция по эксплуатации, Страница: 17 / 36

Operations check
Please turn ignition ON (state which the
warning lights of meter turn on and the
engine has not work), and check that
LED of a dial unit has gone out.
・ When blue LED is blinking, please push dial,
and turn off the light.
・ When red / green LED is on, please click
dial, and turn off the light.
Please start engine, and step on
accelerator lightly.
Please check that an accelerator reacts
as usual and there are no abnormalities,
such as lighting of an engine check lamp.
Please lift a hand in the place which
turned the dial to the left until it is
responsive, and check that green LED
lights up.
Please check that accelerator reacts as
usual, and there are no abnormalities,
such as lighting of an engine check lamp
when accelerator is stepped lightly.
Please check operations after installation as follows.
Please interrupt checking operations when some abnormalities arise, and
remove a cause of troubles by following troubleshooting P31 .
①
②
③
ENGINE
START
STOP
Please step on the accelerator, with the engine started and check whether engine RPM changes.
When there is any changes, please check that it is not forgotten whether to install stock parts
which were removed in addition to this product.
When there is not any changes, please check whether there is any error in wiring according to
vehicle type.
Please turn off check lamp after a check (P30), and redo from the checking of operations ①
once again.
When an engine check lamp lights up ...
‑16‑
Green lighting
↓next page is followed.
A key is turned to
Ignition ON.
Please push button
twice, without stepping
on a brake
(push start type vehicle).
or
Putting out lights
Please step on accelerator lightly.