Power i-Cruise Dial, Инструкция по эксплуатации, Страница: 15 / 36

Please turn ON an ignition key (state which the warning lights of meter turn on and the
engine has not put into operation), and check that all LED of a dial unit has disappeared.
When blue LED is blinking, please let me put out the light by pushing a dial.
When red / green LED is on, please let me put out the light by click operation of a dial.
①
Initial‑setting 1.<Study of an accelerator>
After installation should perform study of an accelerator, and
study (P18) of speed at any cost.
i‑Cruise Dial is made to learn about the characteristic of a pure accelerator first.
If the power supply of this product is turned ON, without performing this study, an engine
check lamp lights up and it cannot run normally.
In addition, if it is made to learn once, even if it removes i‑Cruise Dial, and it removes a
battery terminal, there is no necessity for re‑study as long as it uses it by the same vehicles.
‑14‑
Please continue pushing a dial.
(Although blue LED lights up in about 5
seconds, please continue pushing as it
is.)
If blue LED lights up, please turn to the
right until it is responsive, with a dial
pushed and lift a hand.
Blue LED goes out and green LED blinks.
①
②
Please continue
pushing until blue
LED lights up.
(For about 5 seconds)
If blue LED lights up,
it will right‑click
pushed.
If a hand is
lifted, green LED
will blink.
(Blue LED goes out)
↓next page is followed.
ENGINE
START
STOP
A key is turned to
Ignition ON.
Please push button
twice, without stepping
on a brake
(push start type vehicle).
Putting out lights
or
Caution