Power i-Cruise Dial, Инструкция по эксплуатации, Страница: 19 / 36

Please turn on an ignition key (state which the warning lights of meter turn on
and the engine doesn't work), and check that all LED of a dial unit are turned off.
When blue LED is blinking, please let me put out the light by pushing a dial.
When red / green LED is on, please let me put out the light by click operation of a dial.
①
Initial‑setting 2.<study of speed>
Please perform study of accelerator and speed signal after
installation.
i‑Cruise Dial is made to learn the characteristic of a pure speed signal.
If this product is used without performing this study, the functions, such as auto‑
cruise, will not operate normally.
In addition, if it is made to learn once, even if it removes i‑Cruise Dial, and it
removes a battery terminal, there is no necessity for re‑study as long as it uses it
by the same vehicles.
‑18‑
Please continue pushing a dial.
(Although blue LED lights up in about 5
seconds, please continue pushing as it is.)
If blue LED lights up, please turn to the
left, with a dial pushed and lift a hand
until it is responsive.
Blue LED is blinked.
②
③
If blue LED lights up,
please left‑click.
If a hand is lifted,
blue LED will blink.
↓next page is followed.
ENGINE
START
STOP
A key is turned to
Ignition ON.
Please push button
twice, without stepping
on a brake
(push start type vehicle).
Putting out lights
or
Please continue
pushing until blue
LED lights up.
(For about 5 seconds)
Caution