Power i-Cruise Dial, Инструкция по эксплуатации, Страница: 11 / 36

Main unit
<Brake signal wire (red)>
It is wiring required in order to use
an auto‑cruise function and an
accelerator canceler function.
From the connector of a brake
switch, when you step on a
brake, please connect in search
of the line set to 12V with aｎ
electrical tester etc.
<Reverse signal wire (green)>
It is wiring required in order to
use a back speed assist facility.
When you put into a reverse
gear, please connect with the line
set to 12V.
When you use an auto‑cruise function, in order to cancel auto‑cruise in a
brake, please wire certainly.
Since an electro tap has loose connection's fear, please do not use it for a
brake line (above) and a power source wire (P9) by any means.
If a reverse signal wire is not connected, throttle control and the function
of auto‑cruise will become effective also at the time of retreat.
Please connect a reverse signal wire so that danger, such as jack rabbit
start, does not arise at the time of retreat.
Main unit
Reverse signal
Main unit
‑10‑
Do not use Electro tap.
It connects with soldering.
市販オプションハーネス
の、ブレーキを踏んで
12Vになる線
The line which steps
on the brake of
commercial option
harness and is set
to 12V
The line set to 12V
when it puts into a
backgear
Exchanges to
male terminal.(*)
(*) Please prepare
male terminal
separately.
Please attach using the electro
tap of soldering or attachment.
Installation schematic view and an installation procedure
Work procedure (Each wiring)
The line set to 12V
when a brake is
stepped on The line set to 12V
when a brake is
stepped on
or
red red
green
Brake Brake
Caution
Caution