Poulan Pro PZ4822, Руководство оператора

Страница: 48 / 75

English-
47
MAINTENANCE
To level deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to
the correct pressure. See “Technical Data”
under Transmission. If tires are under or over
inflated, you can not properly adjust your
deck.
NOTE: It may be easier to adjust the front lift
linkages by removing the floor pan before any
adjustments are made.
Side-to-side adjustment
1. Raise the deck into the four inch 4”
(102 mm) cutting position.
2. Measure height from the bottom edge of
the deck to the ground at both front
corners. Distance “A” should be the
same, or within 3/16” (5 mm) of an inch.
3. If adjustment is necessary, make
adjustment to one side of the deck only
4. Remove the securing ring from the top
pin and the bottom clevis pin. Push
bottom clevis pin through deck lift
connector while supporting deck. Adjust
by moving the deck lift connector to a
new hole to lower or raise that specific
corner of the deck. The round hole
closest to the long slot is the shorter
length and will raise the deck, the round
hole farthest away from the long slot is
the longer of the two and would lower the
deck when used.
5. Recheck measurements after
adjustment.
CZ-16
Distances A
8011-645
1. Front lift linkage
2. Hex nut
Adjustment A