Porter-Cable PTS2, Инструкция по эксплуатации, Страница: 6 / 24

6- ENG
D22719
MAINTENANCE
l
Connect tool to air hose of recommended size. NOTE: The use of a quick connect
set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
To use:
l
Turn air compressor on and allow air tank to fill.
l
Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum
90 PSI pressure.
l
Depress trigger to operate tool.
l
Release trigger to stop tool.
l
Adjust variable speed by turning regulator knob
counterclockwise for more air and clockwise for less
air.
l
Always disconnect air supply when changing
sandpaper pads.
l
When job is complete, turn the air compressor off
and store as described in the air compressor operator
manual.
Tips
l
Begin sanding with an abrasive grit sandpaper coarse enough to remove the high
spots. Progress to a finer grit sandpaper until the desired finish is obtained.
l
Never change from coarse grit sandpaper to a very fine grit sandpaper, always
progress to the finer grit.
clockwise
counter-
clockwise
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses
compressed air to power the tool. Because moisture in compressed air will rust the air
motor, you must lubricate the motor daily. An inline oiler is recommended.
To lubricate the air motor manually:
l
Disconnect the tool from the air supply holding it so the air inlet faces up.
l
Depress the trigger and place one to two drops of air tool oil in the air inlet
Depressing the trigger helps circulate oil in the motor.
NOTE : Use SAE #10 weight oil
if air tool oil is not available.
l
Connect the tool to an air source, cover the exhaust end with a towel and run for a
few seconds.
Any excess oil in the motor is immediately expelled
from the exhaust port. Always direct exhaust port
away from people or objects.
Failure to lubricate the tool at the air inlet will void
your warranty.