Porter-Cable PTS2, Инструкция по эксплуатации, Страница: 5 / 24

5- ENG
D22719
ASSEMBLY
SPECIFICATIONS
OPERATION
Free Speed (No Load) 18,000 RPM
Maximum Working Pressure 90 PSI
Pad Diameter 3”, 4.5”, and 5.5”
Air Inlet 1/4" NPT
Recommended Hose Size 3/8" I.D.
Air Consumption @ 90 PSI 12.5 SCFM
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D.
and fittings should have 1/4” NPT thread.
Operation
Before each use:
l
Drain water from air compressor tank
and condensation from air lines. See
air compressor’s operators manual.
Disconnect
the tool from
the air supply before lubricating or
changing sandpaper disc.
l
Lubricate tool, see “Maintenance”
section in this manual.
l
Select the required sandpaper pad
(A) and sandpaper (B).
l
Remove pad nut (C).
l
Press pad nut (C) through sandpaper (B) and sandpaper pad (A).
l
Holding hub (D) assemble pad nut with sandpaper and sandpaper pad.
l
Place holding rod (E) into hole located on hub and tighten securely. NOTE: Holding
rod (E) is used to tighten or loosen hub.
Air Inlet
Pad
Nut
Trigger
Sandpaper
Pad with
Sandpaper
Regulator
Knob
B
A
A,B C
D
E