13
Assembly
The Flexisharp is supplied partly assembled, please assemble the machine
as follows:
1. Remove the large locking wheel from the chain guide assembly and place the bolt end
through the hole in the unit base. Replace the locking wheel on to the bolt and adjust to the
required angle before fully tightening. When installing the Flexisharp on to a work bench,
make sure that the locking screw is easily accessible.
2. Remove the plastic tension nut from
the end of the tension cable. Pull the cable
through the chain guide clamping piece and
replace the plastic tension nut.
Work Surface Mounting
3. Place the unit base on to a solid, level work surface. Ensure the base extends out far enough
over the edge so that the chain can hang freely and you have easy access to the vice angle
adjustment screw underneath. Mount the base to the work surface through the two 9mm
(1/4") mounting holes (bolts not included).
4. The Flexisharp is assembled and ready for use. The pre-installed grinding wheel is for
universal use. To replace a grinding wheel see “Grinding Wheel Replacement” section
Battery release
Press button for battery
charging condition
Locking wheel
Chain clamp
assemby
Tension nut
Flexisharp instructions.indd 13
11/07/2018 13:24
