12
Charging the Battery
Identify all the parts packaged in the carton against the parts list. Remove all protective
materials and place parts on a non-abrasive surface to avoid scratching. Please contact
your dealer if anything is missing. Improper handling or assembly may result in damage
to the chainsaw sharpener or serious injury through faulty assembly.
Assemble the chainsaw sharpener on a stable, non-abrasive surface such as worktable to
avoid damaging the item.
Charging the battery pack
The battery is protected from exhaustive discharge. An integrated protective circuit
automatically switches off the equipment when the battery is flat.
Warning!
Do not actuate the On/Off switch any more if the protective circuit has tripped.
This may damage the battery.
1. Remove the battery pack from the equipment, pressing the
pushlock button downwards to do so.
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. To ensure that the battery pack
provides long service you should take care to recharge it promptly.
You must recharge the battery pack when you notice that the power of the chain
sharpener drops. You can additionally see the level of charge by looking at the battery.
It has a battery check function activated by pressing as shown in picture below. Three bar
led advises power level. It is advised to recharge the battery when it reaches 1 led only.
Never fully discharge the battery pack. Never fully discharge the battery pack by leaving
a used battery for extended time without a small amount of charging. This may cause
the battery pack to develop a defect. Always store with 1 or 2 led’s worth of charge for
optimum life of battery.
Battery release
Press button for battery
charging condition
Flexisharp instructions.indd 12
11/07/2018 13:24
