244
Parking
Deleting programmed signals from
the keys
This process deletes the standard factory-set
codes. Do not repeat this process if you want to
assign additional signals to the buttons.
f
Keep the two outer buttons
and
on
the overhead operating console keypad
pressed for approx. 20 seconds until the
indicator light
A
on the button
starts to
flash quickly.
Assigning garage door opener signal to
key with fixed code system
1. The standard factory-set codes must be
deleted before programming for the
first
time.
2. Press and hold the desired button on the
overhead operating console keypad until the
indicator light
A
on the button
starts to
flash slowly.
You now have 5 minutes to teach the button.
3. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(
figure
) and press and hold the transmit button
until the vehicle’s turn signal lights flash on and
off three times and/or the indicator light
A
starts flashing quickly.
The turn signal lights flash three times and the
indicator light
A
flashes quickly to confirm that
the new signal has been programmed
successfully.
Several attempts with different distances
between the vehicle and the original remote
control may be necessary.
4. The turn signal lights will flash once when the
5 minutes teaching time are up.
Repeat steps 2 to 3.
5. Repeat steps 2 to 4 to assign signals to the
other buttons.
Assigning garage door opener signal to
button with changeable code system
1. The standard factory-set codes must be
deleted before programming for the
first
time.
2. Press and hold the desired button on the
overhead operating console keypad until the
indicator light
A
on the button
starts to
flash slowly.
You now have 5 minutes to teach the button.
3. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(
figure
) and press and hold the transmit button
until the vehicle’s turn signal lights flash on and
off three times and/or the indicator light
A
starts flashing quickly.
