Lights, Turn Signals and Windshield Wipers
103
Rain sensor operation, front windshield
wipers
In rain sensor mode, the amount of rain on the
windshield is measured. Wiper speed is
automatically adjusted accordingly.
At a speed of less than approx. 2 mph (4 km/h),
rain sensor operation is automatically activated if
the windshield wiper is switched on. If you exceed
a speed of approx. 5 mph (8 km/h), the system
changes to the preselected wiper speed.
The rain sensor remains switched off if the wiper
stalk is already in position
1
when the ignition is
switched on.
To switch the rain sensor on again:
f
Move wiper stalk to position
0
and then to
position
1
Switch-on is confirmed by one wipe of the
windshield.
or
Operate windshield washer system
5
.
Switch-on is confirmed by three wipes
of the windshield.
or
Change the sensitivity of the rain sensor
using switch
A
.
Note on operation
In the multi-function display on the instrument
panel, you can configure the rain sensor to
activate automatically when the ignition is
switched on and the wiper stalk is set to
position
1
.
For information on adjusting rain sensor activation
when the ignition is switched on:
f
Please see the chapter “SETTING RAIN
SENSOR ACTIVATION” on page 143.
Adjusting the rain sensor sensitivity
f
Move switch
A
upwards –
high sensitivity.
The setting is confirmed by one wipe of
the windshield.
f
Move switch
A
downwards –
low sensitivity.
Headlight washer system
The washer sprays only while low beam or
high beam is activated.
f
Press button
B
under the wiper stalk.
After every 10 wipes on the windshield, the
headlights are cleaned automatically as well.
The wipe count starts from zero again when the
low beam is switched off.
