Poolspa VICTORIA SPA, Инструкция по установке и эксплуатации

Страница: 9 / 28

9
1.5.4. Setting the right time
The controller is fi tted with the RTC system (real-time clock), which works permanently even after
disconnecting the main power. The RTC system makes it easier to use the SPA, since the controller
memorize the clock, fi ltration and the economy mode setting even after the main power is off. It is
not necessary to set the fi ltration start time and its duration again.
To change the RTC system setting:
Press and hold the clock button for about 5 seconds until the clock icon starts blinking and
appears permanently on the display.
Set the hour by using the up/down arrow buttons
Press the clock button once again to set minutes by using the up/down arrow buttons
Press the clock button once again to save the current setting after the time modifi cation. If no bu-
tton is pressed for longer than 5 seconds, the controller returns to its normal mode without saving
the setting.
1.5.5. Economy mode
After switching on the economy mode (energy saving mode), the controller keeps the temperature
10°C (50°F) lower than that previously set.
When this mode is working, this icon appears on the display. The economy mode can be activated
(the icon is displayed permanently) or suspended for 40 minutes from the moment of switching off the
last pump, when at least one pump is switched on during this mode. Regardless of the temperature
previously set, the controller maintains the water temperature not lower than 15°C (59°F).
To enter the economy mode:
Press this button
The display will then show „Edx”, where x stands for the economy mode duration (from 0 to 24 hours)
Ed0 – the economy mode is switched off,
Ed24 – the economy mode is working continuously.
To change the hour, use the up/down arrows and use this button on the control
panel to confi rm the setting.
After confi rming the settings, the display will show the time when the economy mode is to start.
Set the hour and minutes using the arrows and confi rm the setting with this button
Confi rming the minutes with this button the economy mode is set. The display returns to its
normal status.
The setting of the economy mode is remembered even after the power cut-off.
1.5.6. Filtration
In this system, the fi ltration process is based on water ozonation. The water is sucked by the skim-
mer fi lter and then mixed with ozone by the injector. After that, the water returns to the SPA bath
through the ozone jet. The fi ltration process consists on two steps. The fi rst step lasts 1 minute,