Poolspa VICTORIA SPA, Инструкция по установке и эксплуатации

Страница: 10 / 28

10
water pump work at the highest speed, while the heater is on. When one pump works in a low gear
along with the water ozonator and the electric heater. The duration of fi ltration depends on the time
setting. Filtration mode is indicated by this special icon on the display. Filtration process can be
suspended (the fi ltration icon is blinking on the display) by switching on any of massage pumps.
Filtration will return to its normal mode after 40 minutes after user last operations. Switching the
lighting on does not suspend the fi ltration process.
Setting fi ltration parameters:
Press the fi ltration button
The display will show
Fdxx
, where
xx
stands for the fi ltration duration from 0 to 12 hours.
If xx is set on 0, the fi ltration does not work
Filtration duration can be changed with these arrows and the selected value is confi r-
med by pressing the fi ltration button
The blinking fi ltration start time will appear on the display
Changes are made with these arrows and confi rmed by using the fi ltration button
After confi rming the selected minutes by pressing the fi ltration button, the controller memorizes
the setting and returns to its normal work. If no button is pressed for longer than 5 seconds during
the setting procedure, the controller will quit the fi ltration setting menu and will not remember any
changes.
1.5.7. Fast fi ltration (Boost)
The “boo” function enables to make faster water fi ltration. During this function, all the pumps work for
1 minute. Additionally, pump works in a fast gear for 45 minutes along with the ozonator. The heater
works normally during the fast fi ltration process. After switching this function on, the „boo” sign ap-
pears on the display and is present until this function is fi nished. Fast fi ltration process is triggered
by pressing and holding the pump 1 button for 10 seconds. This function can be switched off earlier
by starting any other pumps.
1.5.8. Setting the water temperature
To set the water temperature, press the arrow buttons on the control panel.
The selected temperature does not have to be confi rmed, but only set. The display, after 5 seconds
from the last pressing, will return to the previous status and start showing the current water tempera-
ture. The controller maintains the set temperature with an accuracy of ± 0,5°C (1°F). If the water
temperature is lower than that previously set, the controller will start the heater and low gear pump
(fi ltration circuit) and keep it on until the water reaches its required temperature. If the economy mode
is on the controller keeps the water temperature lower by 10 degrees than that previously set.
After the economy mode is off, the controller returns to maintaining the previou set temperature.
1.5.9. Increasing the maximum temperature
This function allows the user to increase the water temperature by two degrees centigrade above
40°C (104°F). To set the temperature above 40°C, set the maximum temperature and next press
and hold the up arrow button for 5 seconds until the Orx.x sign appears on the display, where
x.x signifi es how much the temperature value is to be increased above the maximum temperature.
This value can be increased half a degree, and the maximum value is two grades, so the maximum water