3-37
3 First Steps
Scanning
17. Define scan points as described in your PSV software manual.
18. Start the scan. In the menu bar, select
Acquisition > Scan
(toolbar:
).
The software creates a file for the scan. The
Save As
dialog appears.
19. Navigate to the saving location and enter the file name.
20. Click
Save
.
The scan starts. The software immediately saves every scan point
measured.
21. Once the scan is complete, switch to the presentation mode. In the menu
bar, select
View > Presentation
(toolbar:
).
22. Compare the results. The result of the measurement should roughly
resemble the figure below.
If this is not the case, contact the Polytec service department.
Figure 3.27: Result of the scan
Содержание MSA-600
