Preparing Your Room for the Polycom Open Telepresence Experience (OTX) 300 Installation
Page 7 of 32
If you are planning to install the OTX Complete Experience Kit:
The OTX Complete Experience kit includes the OTX rear wall and the ceiling lights. Your Polycom
Certified Project Manager will work with you and your electrician to prepare for the installation of the
lights. Note that it is the customers’ responsibility to purchase and install the ceiling lights in
accordance with all local building and electrical codes.
For more information about the OTX Complete Experience kit lighting requirements:
•
See the lighting plans on pages 28 and 29 and the OTX 300 side view on page 31.
•
See the specification sheet for the lights:
o
For Zumtobel Lighting VAETROS™ lights, which are available in North America, go
to
http://www.zumtobel.us/PDB/specsheet/EN/ZSLI_VTR_2_SPEC.pdf
.
o
For Zumtobel Lighting VAERO-H™ lights, which are available in Europe and other 220V
regions, go to
http://www.zumtobel.com/COM/EN/product_f.htm
, select
Surface-mount
and pendant luminaries
, and then select
VAERO
.
If you are not planning to install the OTX Complete Experience Kit:
If you are not planning to install the OTX Complete Experience Kit, you will not receive the Polycom
lighting; therefore, you must provide your own lighting. Polycom recommends using a lighting
designer and having the lighting professionally installed. The room should have evenly dispersed
ambient light driven from electronic ballast florescent lights (not magnetic ballast).
To ensure proper lighting, you must measure the lighting at seats 1 through 6 in the room.
1
2
3
4
5
6
