4
MODE 1
*INDICATES DEFAULT SETTING
FUNCTION 1
OPTION 1*
Ignition Lock ON
OPTION 2
Ignition Lock OFF
OPTION 3
Ignition Lock ON and locks in
toggle mode.
FUNCTION 2
OPTION 1*
Constant “GROUNDOUT”
OPTION 2
Pulsed “GROUNDOUT”(1 sec)
OPTION 3
Constant “GROUNDOUT” with
disarm pulse on defrost line (pin
# 15)
FUNCTION 3
OPTION 1*
.75 seconds door lock / unlock
pulses.
OPTION 2
4 seconds door lock / unlock
pulses.
OPTION 3
1 seconds lock pulse & 2 – ¼ sec.
Unlock pulses.
FUNCTION 4
OPTION 1*
Trunk release on channel 3 ( will
not receive signal while ignition
is “ON”)
OPTION 2
Garage door transmitter control
(will receive signal with Ignition
“ON”)
OPTION 3
Channel 3 used for activation /
deactivation of cold weather
mode.
FUNCTION 5
OPTION 1*
External trigger disabled
OPTION 2
External trigger enabled
OPTION 3
Child proof Operation
(Transmitter button must be
pressed for 4 seconds)
MODE 2
* INDICATES DEFAULT SETTING
FUNCTION 1
OPTION 1
5 minutes run time
OPTION 2*
15 minutes run time
OPTION 3
25 minutes run time
FUNCTION 2
OPTION 1
2 start attempts
OPTION 2*
3 start attempts
OPTION 3
4 start attempts
FUNCTION 3
OPTION 1
6 seconds crank time
OPTION 2*
8 seconds crank time
OPTION 3
12 seconds crank time
FUNCTION 4
OPTION 1
gasoline engines & enable idle
mode
OPTION 2*
gasoline engines
OPTION 3
diesel engines & enable idle
mode.
VACUUM MODE
The PS-2600 can operate in vacuum mode as
Well as tach mode. Although Vacuum mode
requires an optional
normally closed vacuum
switch.
In order for the PS-2600 to work in vacuum
mode you must first set the tach signal to a
setting of 8 flashes. (see manual tach
adjustment)
The vacuum switch has two contacts, one contact
must connect to the tach input of the PS-2600,
and the other contact must be connected to +12v.
TACH WATCH LOCKOUT
Tach Watch lockout is a safety feature built into
the remote starter to protect the vehicle’s starter
motor. If during remote start the vehicle’s engine
ever cranks the entire programmed crank time
without detecting any tach pulses during the first
crank cycle then the unit will go into tach watch
lockout. The diagnostics for this is 3 quick
parking light flashes when trying to remote start
the vehicle.
If your module is in Tach Watch Lockout it is
indicating that a problem exists with the tach
signal it is receiving. Verify that the tach wire
from the vehicle to the remote starter is properly
connected to a good tach signal.
Содержание PS-2600
Страница 6: ......
