2
Please review the installation guide before
beginning the installation, particularly the wiring
diagram and the list of programming options.
Prior to installation please be sure that all hardware
components required to install the
PS-2600 are in the box.
This is a list of components included in the
PS-2600 kit:
•
1 - PS-2600 control unit
•
1 - Two button / 3 ch. remote transmitter
•
1 - 15 Pin harness (Main harness)
•
1 - 5 Pin 18 AWG harness (Secondary harness)
•
1 Antennae
•
1 Parts Bag (Hood switch, Valet switch,
connector, wires)
•
User guide, Tech updates.
INSTALLATION POINTS TO REMEMBER
•
When working on a vehicle always leave a
window open.
•
Remove courtesy light fuse if possible to
prevent battery drain.
•
Never Install control unit where it could
interfere with normal operation or obstruct
service technicians.
•
Do not disconnect the battery on vehicles
equipped with air bags and anti-theft radios.
•
Always use a grommet when running wires
into the engine compartment. Never run wires
through bare or sharp metal.
•
Always solder and tape all connections.
•
Never ground control unit to vehicle steering
column.
•
Make sure that vehicles equipped with
automatic transmission do not start while in
any of the drive gears
.(If it will start in gear
please install a manual transmission starter)
FEATURES
Dual 12 volt power lines.
12 volt parking light output.
2 Button / 3 channel transmitter.
Factory alarm control.
Gasoline or Diesel engine ready.
Positive and Negative door lock output.
Cold weather timer.
Negative trunk output.
Up to 600 feet range.
300 milliamp ground output (pulsed or
constant)
300 milliamp ground when armed output.
External trigger control (From external
receiver. e
g.: alarm
)
OPTIONS
•
Remote keyless entry
•
Remote Trunk release
•
Engine kill
•
Flashing LED
•
Pager Ready
PROGRAMMABLE OPTIONS
•
Door lock pulse duration ( 1 sec, 4 sec, or
two ¼ sec unlock pulse)
•
Ignition controlled door locks
•
Constant or pulsed Groundout when running
•
Run time (5,15, or 4)
•
Crank duration (6,8, or 12 sec)
•
Child proof operation
•
Gas or Diesel engine mode
TRANSMITTER CODE LEARNING
PS-2600 transmitters do not come
preprogrammed. They must be “CODE
LEARNED” at the time of installation. The unit
will hold up to 4 transmitter codes in memory.
To program a new transmitter you must do the
following:
1. Raise the hood
2. Turn OFF underdash valet switch
3. Turn key to IGNITION position
4. Turn valet switch ON (parking lights will
turn on for 5 sec.)
5. Press either button on transmitter within 5
seconds of step 4. (lights will flash 5 times
fast, and 2 times slow)
6. Turn ignition off and close the hood.
TRANSMITTER FUNCTION
Once programmed, the transmitter will now be
operational. (
only with hood closed
)
The transmitter is equipped with 3 channels,
They are as follows:
1. Button 1 - controls door locks and engine
kill option.
2. Button 2 - controls remote starter and cold
weather timer.
3. Button 3 - controls trunk release option.
Содержание PS-2600
Страница 6: ......
