- 50 -
1800_DE-ANHANGA_SICHERHEIT
Annex -A
EN
safeTy advice
10.) Asbestos
a. Certain sub-supplied components of the vehicle may
contain asbestos due to technical reasons. Please
observe the marking of spare parts.
11.) Transport of people prohibited
a. The transport of people on the machine is not permitted.
b. The machine may only be driven on public roads when
in the position stipulated for road transport.
12.) Driving ability with auxiliary equipment
a. The towing vehicle is to be sufficiently equipped with
weights at the front or at the rear in order to guarantee
the steering and braking capacity (a minimum of 20%
of the vehicle’s tare weight on the front axle).
20%
Kg
b. The driving ability is influenced by the road and
auxiliary equipment. The driving must be adapted to
the corresponding terrain and ground conditions.
c. When driving through curves with a connected
implement, observe the radius and swinging mass of
the implement!
d. When travelling in a curve with attached or semi-mounted
implements, take into account the working range and
swing mass of the implement!
13.) General
a. Before attaching implements to the three-point linkage,
move system lever into a position whereby unintentional
raising or lowering is ruled out!
b. Danger of injury exists when coupling implements to
the tractor!
c. Danger of injury through crushing and cutting exists in
the three-point linkage area!
d. Do not stand between the tractor and the implement
when using three-point linkage external operation!
e. Attach and detach drive shaft only when motor has
stopped.
f. When transporting with raised implement, secure
operating lever against lowering.
g. Before leaving tractor, lower attached implement to the
ground and remove ignition key!
h. Nobody is allowed to stand between tractor and
implement without the tractor being secured against
rolling using parking brake and/or wheel chocks!
i. For all maintenance, service and modification work,
turn driving motor off and remove the universal drive.
14.) Cleaning the implement
a. Do not use high-pressure washers for the cleaning of
bearing and hydraulic parts.
