- 34 -
2000_DE-Wartung_293
EN
MAINTENANCE
Damaged or missing shaft safeguards, protection funnels
or fastening chains must be replaced immediately.
Protect cardan shafts from weather conditions.
At the end of the working season, clean and lubricate all
parts of the cardan shafts thoroughly.
For winter working, grease the shaft safeguards to prevent
freezing.
After longer intervals of non-operation, lubricate the shafts
again and check their correct functionality before starting
work.
Tine arms
WARNING
Risk of injury resulting in death or other serious injury
when transporting dismantled tine carrier.
•
Always hold a tine carrier at the end with the
tines. The tines are turned downwards so
that they do not cause damage to them-
selves or others.
Change tine arms
- Loosen cover bolts (1).
1
- 1. Remove 2x bolts M12x110 (2)
2. Loosen 4x bolts M12x110 (3).
3
2
- Remove
cover
- Pull tine arm out. Turn the rotor unit so that the old
tine arm can be removed from between the intake
and output control (see below).
- Install new tine arm. Turn the rotor unit so that the
new tine arm can be inserted between the intake
and output control (see below).
Direction of
travel
- Re-tighten bolts M12x110 with 1x nut and 2x Nordlock
washers (see illus.)
(tightening torque: 160 Nm)
Position the Nordlock washers with the rough milling
inside on top of one another. This means that both
washers have the fine milling outside.
- Attach cover to the new tine arm, fit it between the
covers and tighten the screw. Tighten all the loosened
bolts (1) for the covers.
- Check the tightness of the bolts and nuts after approx.
50 hours of operation and re-tighten if necessary.
- Pay attention to the position of the dowel pins in
relation to each other. see picture below - Detail B
- Pay attention to the position of the dowel pins in relation
to each other. see picture below - Detail B
B
