Poettinger MULTICAT 9000, Руководство по эксплуатации

Страница: 22 / 35

- 22 -
1) optional equipment
(374) 9800-GB WARTUNG
MAINTENANCE
GB
Installing cutter blades
Take note!
The arrow on the cutter blade shows the cutter disc's direction of turn.
- To install, clean back plates from varnish.
Fahrtrichtung
TD 45/94/23
R E
L I
Winter storage
- Thoroughly clean machine before storage.
- Put up protection against weather.
- Change or replenish gear oil.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication chart.
Cleaning of machine parts
Attention ! Do not use high-pressure washers for the cleaning of bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, grease the machine according to the lubrication chart and carry out a short test run.
- Cleaning with too high pressure may do damage to varnish.
TD 45/94/22
Oil Level
A
Gearing on the conditioner drive 1)
Check oil level: Once a year under normal operating conditions, however after
100 ha. at the latest.
Oil level: The oil level (0.25 litre SAE 90) is correct when it reaches this screw.
Oil change: After 900 ha. at the latest.
1. Remove drain plug (A), drain old oil and dispose of properly.
2. Refill oil at the "Oil Level" screw (0.25 litre SAE90).