Poettinger MULTICAT 9000, Руководство по эксплуатации

Страница: 17 / 35

- 17 -
(361) AUFBEREITER 9601-GB
CONDITIONER GB
Fitting the Conditioner
Fitting is carried out in reverse
order to removal.
1. The conditioner's attaching
elements (10a) are placed into
the holding brackets and fixed
left and right with spring pins
(11a).
2. Raise both jack stands (16a) and secure with spring pin.
3. Check belt tension and adjust if necessary.
4. Connect cardan shaft to the appropriate stub (A, B) on the
conditioner gearing and on the middle gearing.
• See also chapter "Mowing with the conditioner".
5. Check gap of both guiding plates (LB)
- reset correctly if necessary
- gap at least
15 mm
Removing the Conditioner
1. Lower both jack stands (16a) and secure with spring pin.
2. Disconnect and remove the cardan shaft from both sides of the
conditioner drive (GW).
3. Remove both spring pins (11a).
4. Pull the conditioner backwards.
Take care when removing!
The conditioner weighs approx. 190 kg.
TD45/94/24a
GW
TD45/94/17
11
10
16a
A1
6 6
TD 59/96/6
15 mm
15 mm
LB LB
Adjusting the V-belt tension
1. Turn the hexagonal nut (M1) until the compression spring is
pretensioned to 115 mm .
2. Turn hexagonal nut (M2) back until a gap of 15 mm to the bushing
is achieved.
These measurements must be checked and adjusted
if necessary before starting work.
TD59/96/7a
M1
M2 15 mm
115 mm