Pneumax 140-SP, Руководство по установке

Страница: 7 / 36

Pneumax PTO-Driven Compressor Kit Installation Guide
Page 7 of 36
Air compressor installation
Compressor mounting bracket is supplied with kit. Mounting bolts of the proper size are
provided with the Compressor Kits since these are metric thread. The installer can
manufacture a mounting bracket for the Compressor if so desired.
Caution: The air compressor cannot be installed on its side. It must remain upright, with the
air intake on the top.
Once again, remember that the driveline angles on the compressor need to match the
driveline angles on the Power train. If driveline angles are not matched, this could
result in bad vibration issues that could lead to driveline failure or cause the Air
Compressor to fail.
If you have questions concerning driveline angles, please contact your driveline
supplier.
The air inlet on the Air Compressor can be turned to any direction, as the bolt pattern is
symmetrical. This way the air inlet can be turned any direction to ease installation of the air
filter.
The air filter is supplied with the kit along with a T-Bolt clamp. For basic installation, the air
inlet tubing supplied to connect the filter to the air inlet is steel tubing and rubber.
Remember it is an air inlet, just as in an engine. The easiest thing we have found is
aluminum or steel tubing thin wall. DO NOT use flexible exhaust tubing or anything water or
dirt can easily penetrate.