Pneumax 140-SP, Руководство по установке

Страница: 8 / 36

Pneumax PTO-Driven Compressor Kit Installation Guide
Page 8 of 36
Air-oil sump installation
Note: Pneumax will not be responsible for systems where the sump and sight glass are
installed such that the oil level cannot be checked or does not display the correct oil
level due to improper installation.
The sump works best when it is installed so that the sight glass opening is at or below the
level of the Air Compressor.
In some cases, finding room for the sump can be difficult. It is acceptable to mount the oil
sump up to 12 inches higher than the air compressor; however this may require the
installation of an oil inject check valve to prevent oil from flooding the compressor. It is
usually fine, though, without this check valve. Oil inject check valve may be ordered from
Pneumax when ordering the system or can be installed after the system has been tested.
Suggested part numbers for this check valve are available through Pneumax.
The oil fill-sight glass on the Oil Sump is next to the oil fill port. It is necessary to locate the
sight glass in an accessible location for ease of checking or adding oil, usually near a door.
It is the responsibility of the installer to make sure the oil can be reasonably checked and
added if necessary.
Suggested oil to be used in the system:
•
ISO 68 wt Hydraulic Low Foaming Anti-Foaming