TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 7
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
1.2 Installation Instructions
Begin miniWIPER operation by setting the Wiper Control Switch to "WIPE" as described in Chapter
3 of this manual. Begin Cyclops 7 Logger operation as described in the Cyclops 7 Logger Manual.
Operation of both units must begin now since their control switches will not be accessible after they
are mounted in the bracket.
The Cyclops 7 Logger comes with a sensor guard (sensor shade) installed. This will need to be
removed so the Cyclops 7 Logger can be used in conjunction with the miniWIPER. The sensor
retainer that holds the Cyclops 7 sensor in place must remain installed. Install the included wiper
sensor guard to replace the sensor shade. The bracket will grip the sensor retainer and the wiper
sensor guard.
Construct the bracket from the parts supplied
by PME as shown in the picture to the left.
Install bolts and nuts loosely. Please note that
the wiper and Cyclops 7 have different
diameters and so will only fit on one side or the
other of the bracket. Make sure that the paired
brackets match up to form the correct diameter
holes. The miniWIPER will be installed in the
same diameter holes while the Cyclops 7
Logger needs the smaller sized hole at the top.
This will allow the Cyclops 7 Logger to slide
through the larger hole and into the smaller
hole, which will grip the wiper sensor guard.
Rotate miniWIPER and Cyclops 7 Logger until
the Cyclops 7 Logger optical surface and the
wiper pulley axes are as shown in the pictures.
