TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 18
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
2.3 miniWIPERPlot
Begin the program operation by
clicking “miniWIPERPlot.jar”. The program presents the screen
shown below.
The miniWIPERPlot program plots the files
recorded by the miniWIPER. The program reads
all the miniWIPER files in a folder, except the
CAT.txt file.
Select the folder that contains the files recorded
by the miniWIPER. If the miniWIPERPlot
program is run directly from the miniWIPER,
then the program will suggest the folder that is
located on the miniWIPER’s SD card. You may
accept this by clicking “Plot”, or you may click “Select DATA Folder” to browse to your
HOST
computer’s hard drive. If the number of measurements recorded is small, for example a few
thousand, then these can conveniently be plotted directly from the miniWIPER’s storage. However, it
is best to copy large measurement sets to the HOSTcomputer and select them there. The file
access to the miniWIPER is slow.
The miniWIPER’s measurement folders must NOT contain any files besides those the miniWIPER
recorded and the CAT.txt file.
Click “Plot” to begin plotting.
The program
reads all the miniWIPER’s data files in the selected folder. It concatenates these and
presents plots that are similar to the plots shown below.
