Plymovent STRA, Инструкция по установке и эксплуатации

Страница: 5 / 16

160420/0 STRA MG manual EN - 4
STRA extraction rail
The STRA track is delivered in 2 lengths:
STRA-Track - 19.6 ft (5,8 m)
STRA-Track 1/2 - 9.5 ft (2,9 m)
Side brace
There are three different lengths available, 20
in. (500 mm), 30 in. (750 mm) and 6 ft (1800
mm). The brace can be mounted separately or
in pairs using the same brackets.
Side brace clamp kit
The kit includes two aluminum brackets for
one or two side braces, and one clamp. This kit
is available in all three side brace lengths.
Braces can also be ordered separately.
Adjustable mounting kit (vertical)
The kit includes two similar brackets.
They can also be used if the roof is angled
and they can be mounted in both directions.
Maximum angle is 30 degrees. It also includes
two STRA brackets for mounting the STRA rail
to the support leg.
Balancer
The non-locking spring recoil balancer has a
lifting capacity of 17.6 - 37 lbs (8 - 17 kg) with
a cable length of 6.6 ft (2.2 m). The main
function of the Balancer Locking Cable (BLC) is
to control the point of disconnection. As the
hose reaches it’s maximum length, the BLC will
bottom out, in turn pulling the Magnetic Grip
nozzle from the moving vehicle.
Crab trolley
The ventilated sliding crab runs inside of the rail and can be
positioned anywhere along the rail.
Duct connection 8 in. (Ø 200 mm)
STRA end caps
The STRA closed end cap is provided with the
rail, and is mounted to the back end of the rail
for a back in system, or the entrance end of
the rail for a drive through system.
Hose Kit
Hose kits available:
- ST (standard temperature) hose, 400
°
F (205
°
C) continuous,
500
°
F (260
°
C) intermittent,
- HT (high temperature) hose, 900
°
F (480
°
C) continuous,
1,050
°
F (570
°
C) degrees intermittent (upper, mid and lower
hose)
- Hose diameter is either 4 in. or 5 in. (100 mm or 125 mm)
- Magnetic Grabber is either 3, 4 or 5 in. (75, 100, or 125 mm)
The different hose packages which contain the following parts:
- Transition parts
- Exhaust removal hose with clamps
- Hoses: upper, mid and lower hose
- Metal hose saddle
- Safety disconnect handle
- Magnetic Grabber
®
nozzle
- Magnetic Grabber
®
conical tailpipe adapter (available in 3, 4, 5,
6 and 7 in.)