Plymovent STRA, Инструкция по установке и эксплуатации

Страница: 7 / 16

160420/0 STRA MG manual EN - 6
Installation table
Rail height
Distance end
stop - door
Length BLC
Feet (m) Feet (m) Inch (mm)
10 (3 m)
min. 5 (1,5 m) 23.8 (600 mm)
recommended 5.5 (1,7 m) 26.9 (685 mm)
max. 6 (1,8 m) 30.4 (770 mm)
13 (4 m)
min. 6 (1,8 m) 23.9 (600 mm)
recommended 6.5 (2 m) 26.7 (680 mm)
max. 7 (2,1 m) 29.7 (750 mm)
16 (5 m)
min. 7 (2,1 m) 24.4 (620 mm)
recommended 7.5 (2,3 m) 26.9 (685 mm)
max. 8 (2,4 m) 29.6 (750 mm)
4.2 Back-in measurements
Determine the position of:
- Exhaust pipe
- Garage / exit door.
- Distance from exit door to the tailpipe.
1. Determine the location of the exhaust pipe (1) on the vehicle:
- Which side of the vehicle is the tailpipe positioned?
- Where does the exhaust exit the vehicle?
- What is the diameter of the tailpipe?
Measure the height and width of the garage (2). Determine the
type of bay doors:
- Rollup door
- Segmented panel overhead door (four-fold doors)
- Other type
Determine the height of the rail that can be installed under the
door when fully raised.The height should be in line with the
specifications indicated in this manual in order to ensure correct
product performance.
Measure the distance between the door and the exhaust pipe
(3). This is the minimum length of the STRA rail. Check before
installation that this is the minimum required length of the STRA
back-in application.
The distance from the end of the rail to the door(s)
must be in line with the installation table above.
2
3
1
CAUTION!
Be sure to order the right grabber dimension. If a
incorrect version is used on the tailpipe, the system
could be damaged or will not properly remove
exhaust from the facility.
4.3 STRA rail location
1. STRA Rail
2. Tailpipe
3. Bay door
4. Rail height
5. Distance to vehicle
6. Distance to exit door
Side view
End view
• The STRA rail (1) is mounted at a height (4) between 12 and
14 ft (3,7 and 4,3 m) over the floor on the side in which the
tailpipe (2) is located.
The first rail hanger leg should be approximately 4 to 5 ft
(1.2 to 1.5 m) from the end of the STRA rail.
• The rail should be mounted 18 to 24 in. (460 to 610 mm)
from the body of the vehicle (5), and positioned on the
tailpipe side of the vehicle. Preferably the rail is on or within
the boundaries of the exit door. Measure the garage door and
truck width in order to determine the rail mounting position.
• The rail should be mounted immediately under a sectional
door with a clear height from the track to the door of 4 to 6
in. (100 to 150 mm).
1
2
4
6
3
5
1 8 to 24
in.