Plymovent STRA, Инструкция по установке и эксплуатации

Страница: 11 / 16

160420/0 STRA MG manual EN - 10
• Attach the mid hose (6) to the long side of the metal saddle
with the supplied hose clamp. The ST mid hose is directional,
so install with directional arrow pointing up or with the
airflow.
• With the balancer holding the hose all the way up cut the mid
hose at approx 4 ft (1,2 m) from the floor and attach to the
Safety Disconnect Handle with the supplied hose clamp (7).
• Make sure the height of the Grabber nozzle is between 14 in.
and 18 in. (35,5 to 45,7 cm) from the finished floor.
• Slide the completed trolley in the rail with the
balancer facing the driving direction / exit door.
4.9 Installing the end caps
• With a 8.5 mm drill make a hole at 0.9 in. (22 mm) from end
of rail (1).
• Mount end socket with hydraulic shock absorber at the exit
side and mount the end cap with cover or end cap with duct
connection with 4 pcs of M8x20 bolts and nuts that are
provided. Do not use self-drilling tech screws (2).
• Repeat for the back end cap, but do not install until the rail is
hung, so you can install the crab/trolley.
• After installation, fine tune the BLC if the disconnection point is
not close enough to the door.
0.9 in. (22 mm)
1
4.10 Install the PC-500 pressure switch
Please refer to the separately delivered manual for installation.
4.11 Install the tailpipe connector
1. Distance exhaust pipe-truck body
2. Tailpipe
3. Conical tailpipe adapter
4. Tailpipe bracket
• The distance between the middle point of the tailpipe and the
body of the vehicle (1) must be at least:
- 3 in. (75 mm) in all directions for a 3 in. (75 mm) system
- 4 in. (100 mm) in all directions for a 4 in. (100 mm)
system
- 5 in. (125 mm) in all directions for a 5 in. (125 mm)
system
This should be checked before the conical tailpipe connector is
attached.
• The end of the tailpipe (2) must be cut in a 90° angle and all
sharp edges must be ground off.
• The conical tailpipe adapter (3) is positioned on the tailpipe.
When attached the minimum space between the tailpipe
connector and the body of the vehicle should now be at least
0.6 in. (15 mm) from the top and both sides of the tailpipe
adaptor.
• The tailpipe support/hanger (4) must be positioned within 20
in. (500 mm) from the exhaust pipe end (2). If not, the
optional tailpipe bracket must be installed. (see: option:
installing the tailpipe brackets)
• The exhaust pipe must be in a 90° angle to the truck body
with a max inclination of 5°.
• The distance between the exhaust pipe and the wheel must
be a minimum 12 in. (300 mm).
• The tailpipe adapter must be installed flush with the
body of the vehicle in accordance to NFPA1500 (5). Make
sure you meet EN-1846-2 requirements related to minimal
clearance to the road.
6
7
2