Plymovent STRA, Инструкция по установке и эксплуатации

Страница: 9 / 16

160420/0 STRA MG manual EN - 8
4.6 Inserting the rubber seal
1. STRA profile
2. Rubber seal
3. Tool no. 0000102158
• Turn the rail profile with the opening upwards. The rubber lip
seal can be easily installed with the Plymovent STRA Lip Tool
before hanging the rail from the support legs; or you can
install the lip after the rail is hung from the support legs.
• The rubber lip seals are directional and must be installed with
the inside bend towards the center of the rail (angled inward
and facing each other). With the rail still on saw horses, install
the rubber lip with the bend facing inward. To make this easier,
spray the lip and aluminum channel with a soapy solution.
• Start installing the first 6 in. (150 mm) of rubber lip by hand
using a screwdriver and then position the lip tool on the rail to
roll the rest of the lip into the bend. Cut the ends at a 90
degree flush with the end of the rail. Repeat for the other side.
4.7 Connect to duct and lift the rail
• On the top of the rail, lay out 3/8 in. holes for the leg
mounting feet locations, to match the distances between the
leg assemblies previously hung from the ceiling. The
maximum end of rail to the first hanger leg should be 4 to 5
ft (1,2 to 1,4 m). A cantilever under the garage door may be
required.
• Pre drill these holes. Raise the pre-assembled rail using
multiple scissor lifts or lifting mechanisms such as a chain
fall. Position rail under leg assemblies and attach with
hardware.
• Plymovent recommends lifting a continuous length of rail up
to 100 ft (30 m) maximum, in which the maximum distance
between the lifting points is 33 ft (10 m).
Top suspension:
• Lift the rail according to the instruction and fix the bolts on
the RRTS lower bracket (1).
• When the rail is in the right position fix the suspensions with
the bolts.
• Fasten the suspensions with the security bolt.
Side suspension:
• The leg is connected to the vertical support legs with
couplings.
• Adjust the rail both vertically and horizontally until it is level.
• Tighten the couplings thoroughly and screw a safety bolt,
which is required (2).
1
5
max. 13 ft.
2
3
4