26
ULTRAPLEX 40X OPERATION MANUAL
To remove your computer’s cover, follow the directions provided by your
computer’s manufacturer. Typically, this involves loosening or removing
several screws on the back panel of your computer and sliding off your
computer’s cover.
Carefully remove the SCSI interface board from its packaging. Select a vacant
slot in your computer where you will install the board (refer to the manual
packaged with your interface board for instructions as to which slot in your
system to use). Plextor provides only 32-bit PCI SCSI interface boards with its
UltraPleX SCSI card bundles. Be sure to use the correct slot (16-bit slots are
longer than 32-bit slots). Older systems may not have a PCI slot, as this is the
newer technology. If you're installing an internal drive, try to pick a slot that is
closest to where the drive will be installed.
Remove the cover plate for this slot from the back panel of your computer.
Keep the screw from the cover plate nearby, as you will need it in a moment.
Save the cover plate in case you need it at a later date.
Plug the SCSI interface board into the slot you have selected. Rock the board
from end to end to ensure that it seats firmly in the slot. Don’t force it. If you
cannot push the board down completely into the slot, remove the board and
try again.
CHAPTER 8 — Hardware Installation
Expansion Slot Cover
Rear Panel
Содержание PX-40TSe
Страница 93: ......