69
Setting up and Configuring vDisplay IP Engines
Saving Your Configuration Settings
You can use the options available in the
UserSetControl section
of the
GEV Device Control
dialog box
to save the changes you make to the vDisplay IP engine default settings. Once saved, the changes (saved
as user sets) can persist across power cycles. Currently, the vDisplay IP engine supports two user sets:
UserSet1
, which consists of the user configured settings, and
Default
, which consists of the pre-
configured settings. Settings identified as
Default
in the
GEV Device Control
dialog box cannot be
changed.
The following table describes the options available in
UserSetControl
.
Table 9: Saving Configuration Options
Setting
Description
UserSetSelector
Selects the feature user set to load, save, or configure.
UserSetLoad
Loads the user set specified by
UserSetSelector
to the device and
makes it active.
UserSetSave
Saves configuration data to the user set specified by
UserSetSelector
,
which is part of the non-volatile memory of the device.
UserSetDefaultSelector
Selects the feature user set to load and make active when the device
is reset.
UserSetLoadLastUserSet
Shows the last user set executed by the IP engine from a
UserSetLoad
command, or as a result of a reset of the IP engine.
UserSetLoadStatus
This option indicates the success or failure of the last user set applied.
The user set can be applied through a power cycle or through user
selection.
To save a configuration change to UserSet1
1.
In the
GEV Device Control
dialog box, make appropriate configuration changes.
2.
Scroll to the
UserSetControl
section and change the
UserSetSelector
setting to
UserSet1
.
3.
Click
UserSetSave
.
To load the default configuration settings
1.
In the
UserSetControl
section of the
GEV Device Control
dialog box, select
Default
in the
UserSetSelector
box.
2.
Click the
UserSetLoad
setting and then click the
UserSetLoad
button that appears to the right.
The default settings are applied to the vDisplay IP engine.
