CMO-1500
DT Istr (CMO-1500)_04/17_Rev.1_05/18
12/24
2.
This appliance must be connected to an approved mains socket that complies with the safety regulations on
electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage
and must be equipped with an earth cable.
3.
The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use
other than its intended purpose shall be deemed to be improper and hazardous.
4.
The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5.
Always place the fan heater on a flat and even surface, it should not be exposed to vibration or mechanical
stress.
6.
The appliance must be placed at a minimum distance of 50 cm from any combustible materials as furniture,
pillows, bedding, paper, clothes, curtains, plants, etc.
7.
In order to have a good air aspiration and to avoid damaging of the product, maintain the air inlet and outlet
free from objects.
8.
The appliance has dangerous components that must be kept out of the reach of children.
9.
Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
10.
The power cord must never be in contact with the hot surfaces of the appliance.
11.
Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
12.
If the appliance does not work properly, immediately turn it off and disconnect it from the mains socket.
For repairs, contact a technical support center authorized by the manufacturer, and require that original
spare parts be used. Using parts that do not conform to the product may seriously compromise its correct
operation.
13.
In order to unplug the appliance, select
"
●
"
and disconnect the plug from the power socket.
INSTRUCTIONS FOR USE
The fan heater features a top panel with knobs to select the different functions:
During operation the fan heater must be at a minimum distance of 50 cm from walls or other objects. Direct the
air flow towards such a point so that room heating is optimised. Do not direct the heat flow towards corners or
reduced spaces, or towards the floor or ceiling.
1
Thermostat Knob
2
Power light
3
Power knob
4
Air outlet
5
Base
Power Knob
"
●
"
OFF
Fan function: cold air flow
"I"
Heating function at minimum power
"II"
Heating function at maximum power
Auto swing function
Thermostat knob
The fan heater is equipped with a thermostat for temperature
adjustment. Turn the adjustment knob clockwise to increase
the temperature (and, therefore, the power). Turn the
adjustment knob anticlockwise to reduce the temperature
(and, therefore, the power).