Playcraft Farm Sound Panel Insert R5, Руководство по установке

Страница: 120 / 314

IMPORTANT NOTES: Read First
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or 541.955.9199 (International)
ARCH SWING ASSEMBLY R5
INSTALLATION INSTRUCTIONS
Rev Q
7/31/2019
PC-2120
Page 1 of 8
See Footing Detail
Figures
1.1 & 1.2
Figure 1.3
Figure 1.5
Figure 1.6
Figure 1.4
See Installation Manual
Section PC-131410
Inclusive Swing Seat
(A) Use liquid thread lock (such as Loctite ® ) with all threaded hardware. Impo rtant: Liquid thread lock (prior to
curing) helps to eliminate the common problem of "thread seizure" in stainless steel hardware by serving as a
lubricant during assembly.
(B) Do not pour concrete until the equipment is completely assembled, leveled and plumbed. Concrete must be
allowed to cure completely before using the equipment (at least 72 hours).
(C) Important: Full bucket seat swings should be suspended from structures that are separate from those
used for other swings, or at least suspended from a separated bay of the same structure . According to the
Handbook for Public Playground Safety, Publication #325 at www.cpsc.gov.
(D) Refer to CPSC for appropriate swing spacing.
(E) Chain length should be adjusted (trimmed) so that the underside of the belt swing is no less than 12"
(Bucket Seat 24") from Finish Grade. See Recommended Swing Seat Heights.
(F) Important: Do not modify hanging position of ADA swings. (e.g. shortening chain, etc.)
(G) Important: Use Arch Swing Casting stamped Belt for all To-Fro swings.
(H) All bolt threads protruding beyond the nut must be cut and de-burred until end is smooth to the touch.
Sharp edges and/or points of any kind must be eliminated. A maximum of two threads may be exposed beyond
the end of the nut.
(I) An appropriate energy absorbing safety surface is required under and around all playground equipment.
Loose fill protective surfacing is shown only as an example for the purpose of this assembly instruction. Other
surfacing material may vary in thickness and/or compression depths. See free publication - The Handbook for
Public Playground Safety, Publication #325 at www.cpsc.gov for the surfacing appropriate for the fall height of
the equipment or consult your surfacing supply representative.
FIGURE 1
Arch Swing R5
NOTE : 3 Bay R5 Arch Swing shown.
Other configurations will vary slightly,
but does not affect the assembly.