6
3.
INSTALLATION
3.1.
Box contents
•
1x complete gas fireplace
•
1x Wall Switch
•
1x remote control and 2x AAA Batteries
•
4x AA Batteries
•
Bag of decorative stones (quantity depend on fireplace length)
•
1x 4 metre rubber gas linkage
–
installed (only LPG version)
•
1x pressure regulator (37mbar)
–
installed (only LPG version)
•
4x Tempered glass guards
•
1x installation and user’s manual
3.2.
Unboxing and installation
•
The contents of the boxes need to be carefully unwrapped from the foam foil.
•
Remove the bags with decorative stones from the burner reservoir and place them away from it.
•
Remove the Styrofoam placed on the unit.
•
Check the completeness of the elements with the contents list.
•
Make sure that the insert nor its elements weren’t damaged during the transportation (if they were, notify
the supplier).
•
Install the Galaxy Burner fireplace in the prepared housing made according to the specification.
•
The decorative stones are to be scattered evenly around the reservoir to completely cover the burner of the
fireplace.
WARNING!
The stones may not cover or be placed inside the device protecting the ignition unit.
Fig. 1
–
Decorative stones location
•
In the case of Galaxy Burner powered with natural gas, to obtain the optimum image of the flame, cover the
burner with a single layer of decorative stones leaving some spaces uncovered of approximately every 10 cm.
Fig. 2
–
Decorative stones location on burner
•
If all the points were completed according to the instruction the gas cylinder can be now connected.
•
The appliance must be used with decorative stones supplied by the manufacturer. Use without stones is
prohibited.
