Piusi cube mc, Руководство по эксплуатации и обслуживанию

Страница: 12 / 28

H4 HYDRAULIC CONNECTIONS
H5 ELECTRICAL CONNECTIONS
H4.1 MAXIMUM LENGTH OF THE SUCTION PIPES
SUCTION LINE
The diameter of the "Ds" suction line must be selected according to the station model and the
position of the station with respect to the tank.
With reference to the "Hp" and "Ls" values indicated at point H2, the following MINIMUM
DIAMETERS of the suction pipe must always be ensured.
The maximum length of the tubing, the diameter of the tubing, the difference in height, are
parameters that are tightly linked to creating suction conditions. The latter must not be such
as to create backpressure greater than 0.6 bar. It follows as a consequence that, after
respecting the minimum diameter of the tubing specified in the "Recommendations and
Warnings" below, the length of the tubing decreases as the difference in height that the diesel
fuel must overcome increases and vice versa: in fact, the back pressure progressively
increases by 0.08 bar for every meter increase in the static height of the pump with respect to
the level of the diesel fuel in the tank.
The power connections must be workmanlike performed by skilled personnel, in strict
compliance with the laws applicable in the country of installation and with the instructions on
the wiring diagrams in this manual.
Maximum acceptable electrical parameter variations are
±5% .
RECOMMENDATIONS AND WARNINGS:
- The suction pipe must resist a pressure of at least 10 bar and must be of a diameter
NOT LOWER THAN 1'' 1/4.
- The tubing must be suitable to functioning under backpressure.
- Use tubing and accessories suitable for use with diesel fuel. Materials that are not
suitable for use with diesel fuel can cause damage to the pump, harm people and
cause pollution.
- Any curves in the suction pipes must be of the widest radius possible to limit the loss of head.
- Make sure that the suction pipe is clean and free of scum.
EN
12
(Translated from Italian)
In all cases, always take the following PRECAUTIONS:
- Use pipes and connections suitable for vacuum operation.
- Use pipes and accessories suitable for use with diesel fuel. Materials that are not suitable
for such use can cause serious damage to the pump or injury to people; they can also be
the cause of pollution.
- Do not use conical threaded connectors that could cause damage to the threaded
connector on the pump filter.
- Use large-radius bends so as to reduce flow resistance to a minimum.
- Make sure that the suction pipe is clean and free of scum.
- At the end of the suction pipe, always fit a FOOT VALVE complete with FILTER. The valve
must be placed on the bottom of the tank and be of the SAME DIAMETER as the pipe.
- Before starting installation, make sure no packaging materials are trapped in the pipes.
! ATTENTION
The CUBE MC dispenser does not feature overload cutouts and, consequently, a
switchboard must be fitted upstream of the CUBE MC complete with residual current
circuit breaker suitable for the type of CUBE MC to be installed.
! ATTENTION