Section One: ASSEMBLY INSTRUCTIONS
ATTACHING ENCLOSURE KIT TO THE UNIT:
(models SC only)
Installation Steps
Page 10
Step 3 Attach Rear Panel:
You will require the 1 x Rear Cart Panel and 4 x 5/32 screws.
This panel will install with the exterior of the panel
will be flush with the outside edge of the legs and
the bottom shelf.
Line up the four (4) pre-drilled screw holes on the
sides of the legs, with the holes on the side of the
panels. Hand start each of the screws first, then
use the correct tool to secure them firmly to the cart
shelf.
WARNING!
Due to the size and weight of the upper grill, the
following installation step is a two (2) person job.
NOTE:
Damaged caused due to ignoring warning or improper
installation is NOT a warranty issue.
Step 4 Attach The Grill And Leg Assembly
You will require the upper grill, leg assembly and 16 x 1/4-20 screws.
Carefully lift the Barrel Smoker up and unto the Leg assembly.
Note:
This may require 2 people.
The Barrel Smoker will slide down and over the leg assembly.
OR
Carefully stand the grease spout end of the barrel on a protective floor
covering. Then insert the legs into the barrel. This makes a single
person installation much easier.
Starting at one leg:
Line up the pre-drilled and cinch nut installed holes on the leg,
(see diagram for location), and the punched hole on the side of the
smoker. There are two (2) on the front and on the side of each leg.
Using a Phillips head driver, install 4 of the supplied 1/4” - 20
Screws (AA) into each leg, to secure each leg to the Barrel.
NOTE: It is best to start each threaded screw by hand, to
ensure the thread DOES NOT cross thread or strip.
When one leg is complete, continue the same steps. On the remaining 3 legs.
Step 2 Attach Side Panels:
You will require the 2 x Side Cart Panels and 8 x 5/32 screws. Both
Side Panels are identical.
Install the right hand side panel first. The exterior of the
panel will be flush with the outside edge of the legs and
the bottom shelf.
Line up the four (4) pre-drilled screw holes on the sides
of the legs, with the holes on the side of the panels.
Hand start each of the screws first, then use the correct
tool to secure them firmly to the cart shelf.
Install the left panel, following the same procedure.