WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
IMPORTANT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
THE STANDBY/ON BUTTON IS SECONDARY CONNECTED
AND THEREFORE DOES NOT SEPARATE THE UNIT FROM
MAINS POWER IN STANDBY POSITION.
CAUTION
This product contains a laser diode of higher class than 1.
To ensure continued safety, do not remove any covers or
attempt to gain access to the inside of the product.
Refer all servicing to qualified personnel.
The following caution label appears on your unit.
Location: rear of the unit
ATTENTION:
AFIN DE PREVENIR TOUS
RISQUES DE CHOC ELECTRIQUE OU DE DEBUT
D’ENCENDIE, NE PAS EXPOSER CET APPAREIL A
L’HUMIDITE OU A LA PLUIE.
This product complies with the Low Voltage Directive (73/
23/EEC), EMC Directives (89/336/EEC, 92/31/EEC) and CE
Marking Directive (93/68/EEC).
Ce produit est conforme à la directive relative aux appareils
basse tension (73/23/CEE), aux directives relatives à la
compatbilité électromagnétique (89/336/CEE, 92/31/CEE) et à la
directive CE relative aux marquages (93/68/CEE).
ATTENTION
Ce produit renferme une diode à laser d’une catégorie
supérieure à 1. Pour garantir une sécurité constante, ne
pas retirer les couvercles ni essayer d’accéder à
l’intérieur de l’appareil.
Pour toute réparation, s’adresser à un personnel
qualitié.
La note suivante se trouve sulr le panneau arrière de
cet appareil.
Emplacement: arrière de l’appareil.
CLASS 1
LASER PRODUCT
IMPORTANT
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in
accordance with the following code:
Blue
: neutral
Brown : live
If the plug provided is unsuitable for your socket
outlets, the plug must be cut off and a suitable plug
fitted.
The cut-off plug should be disposed of and must not
be inserted into any 13 amp socket as this can result
in electric shock. The plug or adaptor of the distribution
panel should be provided with a 5 amp fuse. As the
colours of the wires in the mains lead of this appliance
may not correspond with coloured markings
identifying the terminals in your plug, proceed as
follows:
The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Do not connect either wire to the earth terminal of a
three-pin plug.
NOTE
After replacing or changing a fuse, the fuse cover in
the plug must be replaced with a fuse cover which
corresponds to the colour of the insert in the base of
the plug or the word that is embossed on the base of
the plug, and the appliance must not be used without
a fuse cover. If lost, replacement fuse covers can be
obtained from your dealer.
Only 5 A fuses approved by B.S.I. or A.S.T.A. to B.S.
1362 should be used.
Ventilation
When installing this unit, make sure to leave space around the
unit for ventilation to improve heat radiation (at least 30 cm at top,
15 cm at rear, and 15 cm at each side). If not enough space is
provided between the unit and walls or other equipment, heat
will build up inside, interfering with performance or causing
malfunctions.
Ventilation
Lors de l'installation de l'appareil, veillez à laisser suffisamment
d'espace autour pour permettre une bonne ventilation et
l'évacuation de la chaleur (au moins 30 cm au-dessus, 15 cm à
l'arrière et 15 cm de chaque côté). S'il n'y a pas suffisamment
d'espace entre l'appareil et les parois ou les autres équipements
qui l'entourent, la chaleur s'accumule à l'intérieur de l'appareil et
affectera ses performances ou causera des dysfonctionnements.
CLASS 1
LASER PRODUCT
En/Fr
LE BOUTON STANDBY/ON EST RACCORDE
SECONDAIREMENT ET PAR CONSEQUENT NE SEPARE
PAS L’APPAREIL DE L’ALIMENTATION SECTEUR SUR LA
POSITION D’ATTENTE.
This product is for general household purposes. Any failure
due to use for other than household purposes (such as
long- term use for business purposes in a restaurant or use
in a car or ship) and which requires repair will be charged
for even during the warranty period.
Ce lecteur est un produit grand public destiné à un usage
domestique. Si vous l’utilisez à d’autres fins (par exemple,
pour la sonorisation d’un restaurant, ou bien dans un
véhicule ou un bateau), les réparations éventuelles vous
seront facturées, même s’il est encore sous garantie.
